Near the job site "Tartak" on ProMods, there is a bit of non-solid ground.
I tried to follow the guide linked in "How to report", but I just couldn't get the coords to work.
Refer to the timestamps in the linked video below on how to find the exact location.
I have not edited the clip whatsoever, as to not skew the "evidence".
Video https://youtu.be/RfXqRXfLv2M
Log
PS: I hope this report fulfills your needs. As mentioned, I couldn't get the coords to work, so please excuse me for that. If anything else is missing, tell me and I can try to clear anything up
[Fixed] [#30409] [2.51] Non-Solid ground near "Tartak" by Rzeszów
-
- Posts: 4
- Joined: 16 Jan 2020 17:52
- Contact:
Last edited by bmwGTR on 18 Mar 2021 18:14, edited 1 time in total.
Hi ColinShark,
Out of curiousity, which step of this procedure could you not complete when trying to enable coordinates?
Out of curiousity, which step of this procedure could you not complete when trying to enable coordinates?
Ex-ProMods tester and ex-Moderator. Translator of the official ETS2 + ATS Hungarian localizations. Ex-Community Beta tester of SCS Software. Retired Admin of RestaCar.hu. Pre-recorded DJ at ETS2 RestaCar Pirate Radio.
Drive safe and be nice!
Drive safe and be nice!
-
- Posts: 4
- Joined: 16 Jan 2020 17:52
- Contact:
I edited the config and tried taking the F11 screenshot ingame. The screenshot simply did not happen. I checked my settings for keybinds and tried with the F10 key (which /was/ my screenshot key) and that didn't work either.
I could try again later today, if you want me to.
(As this thread has been approved/made public, I think the video was enough for finding the spot :D )
I could try again later today, if you want me to.
(As this thread has been approved/made public, I think the video was enough for finding the spot :D )
Last edited by bmwGTR on 18 Mar 2021 11:24, edited 1 time in total.
-
- Posts: 1197
- Joined: 20 Dec 2017 13:14
- Donation rank:
The ground without collision is not exactly on the road but you can easily go on it by mistake when you try to enter the company so i reported as #30409
-
- Information
-
Who is online
Users browsing this forum: No registered users and 0 guests